This behaviour is in both Design and Setup -tabs:
If I drag some Section or Event, I can drag only within visible area. So I have a problem with sorting, if i.e. some event is so long, that it fills most of the current screen. Currently I need to zoom out so that I can see top of that Event, to be able to drag an event from bottom to top of it. If the event is a bit longer, I need to zoom out so much that it becoms difficult to spot the yellow arrows.
If the page would scroll while I drag the element to top of bottom of the area, then I would just need to wait until the scroll is at point when I can release the sorted item again, it would be OK. Or, if there was a button "move up" or "move down", this also would be done with. So a my suggestion is to add either one to future versions.
Also it would be good if there was a possibility to rename the Event or Section after it has been created.
Small things, but hopefully also small to add at some point🙂
If I drag some Section or Event, I can drag only within visible area. So I have a problem with sorting, if i.e. some event is so long, that it fills most of the current screen. Currently I need to zoom out so that I can see top of that Event, to be able to drag an event from bottom to top of it. If the event is a bit longer, I need to zoom out so much that it becoms difficult to spot the yellow arrows.
If the page would scroll while I drag the element to top of bottom of the area, then I would just need to wait until the scroll is at point when I can release the sorted item again, it would be OK. Or, if there was a button "move up" or "move down", this also would be done with. So a my suggestion is to add either one to future versions.
Also it would be good if there was a possibility to rename the Event or Section after it has been created.
Small things, but hopefully also small to add at some point🙂